Transition Molding Hardware

Slim Track

At Versatrim, we designed our Slim Track to perfectly fit our Slim Trim and Slim Cap solutions, so you can have the same molding on thin floors up to 1/8” (3mm) in thickness, as you would any other floor. To be used in conjunction with the Versatrack Shim with thicknesses of 1/8” (3mm) to 1/4” (6.35mm).

Material: Cold Roll Steel

Length: 94″ Long

Versatrack (Metal Track)

To be used with T-Molding for floors from 23/64”-15/32“ (9-12 mm) thickness* and Reducer & End Cap for floors from 9/32”-15/32“ (7-12 mm)* thickness. Can also be used with T-Molding in conjunction with the Versatrack shim for floors from 15/32”-45/64” (12-18 mm)* thickness and with Reducer & End Cap in conjunction with the Versatrack shim for floors from 15/32” -5/8” (12-16 mm)* thickness. 

Material: Cold Roll Steel

Length: 94″ Long

For floors thicker than 45/64” (18 mm)* for T-Molding and 5/8” (16 mm)* for Reducer & End Cap, please contact our team of customer service representatives for assistance in choosing the right reducer molding for your project.

Versatrack Shim

To be used with T-Molding in conjunction with the Versatrack for floors from 15/32” – 45/64” (12-18 mm)* thickness and with Reducer & End Cap in conjunction with the Versatrack for floors from 15/32” – 5/8” (12-16 mm)* thickness. 

Material: Standard HDF

Length: 94″ Long

Thin Track – Versatrim Thin

To be used with T-Molding, Reducer, and End Cap for floors from 19/64” – 3/8” (7.5-9.5 mm)*.  

Material: Impact Polystyrene

Length: 94″ Long

If your project calls for flooring with a 7mm thickness, then you must use the Versatrack (Metal Track) in order to install your Versatrim reducer transitions strips. Contact our team with questions you may have regarding which hardware will work best for your projects’ needs. 

Dowel Tree

To be used with SlimTrim for floors up to 3/4” (19mm)*. Comes as a tree of 8 dowels. One tree covers one 94″ long Slim Trim molding with each dowel spaced approximately 12″ apart and 1″ from each end.

Material: High Density Polyethylene

*With our trim molding and all other flooring and stair solutions, all references to flooring thickness refer to the total thickness of all members of the floor installation being used on top of the subfloor. This is typically comprised of the flooring plank (i.e., vinyl or laminate), the underlayment–either loose lay or actually attached, and any additional vapor barriers.